Console Port Connector Pinout Information For An Ex Series Switch; Table 17: Ex Series Switches Console Port Connector Pinout Information - Juniper EX4600 Series Hardware Manual

Related
Documentation

Console Port Connector Pinout Information for an EX Series Switch

Table 17: EX Series Switches Console Port Connector Pinout Information

Pin Signal
1 RTS Output
2 DTR Output
3 TxD Output
4 Signal Ground
5 Signal Ground
6 RxD Input
7 CD Input
8 CTS Input
Related
Documentation
* Optics, Fans and Power supply sold separately for EX4600-40F-S.
Copyright © 2014, Juniper Networks, Inc.
Console Port Connector Pinout Information for an EX Series Switch on page 45
Connecting an EX4600 Switch to a Network for Out-of-Band Management on page 155
The console port on an EX Series switch is an RS-232 serial interface that uses an RJ-45
connector to connect to a console management device. The default baud rate for the
console port is 9600 baud.
Table 17 on page 45 provides the pinout information for the RJ-45 console connector. An
RJ-45 cable and an RJ-45 to DB-9 serial port adapter are supplied with the switch.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to an EX Series switch, use a
combination of the RJ-45 to DB-9 female adapter supplied with the switch
and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Clear to send
EX2200 Switches Hardware Overview
Rear Panel of an EX3200 Switch
Rear Panel of an EX3300 Switch
Rear Panel of an EX4200 Switch
EX4300 Switches Hardware Overview
Front Panel of an EX4500 Switch
Chapter 8: Port and Interface Specifications
45