Device; Figure 45: Ethernet Management Port On The Re Module In Ex9200; Figure 46: Ethernet Cable Connector - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation
Connecting an EX9200 Switch to a Management Console or an Auxiliary Device
158

Figure 45: Ethernet Management Port on the RE Module in EX9200

Switches
Auxiliary Ethernet
port port
Extractor
clip
Console USB Reset
port port button
Connecting an EX9200 Switch to a Management Console or an Auxiliary Device on
page 158
Ethernet Port Connector Pinout Information for an EX9200 Switch on page 121
Cables Connecting the EX9200 Switch to Management Devices on page 115
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate Console (
CONSOLE
use a laptop, modem, or other auxiliary device, connect it to the auxiliary (
the RE. Both ports accept a cable with an RJ-45 connector. One serial cable with an RJ-45
connector and a DB-9 connector is provided with the switch. To connect a device to the
port and another device to the
CONSOLE
Ensure that you have an Ethernet cable with an RJ-45 connector available. An RJ-45
cable and an RJ-45 to DB-9 serial port adapter are supplied with the device.
Figure 46 on page 158 shows the RJ-45 connector of the Ethernet cable supplied with the
switch.

Figure 46: Ethernet Cable Connector

NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to the device, use a combination
of the RJ-45 to DB-9 female adapter supplied with the device and a USB to
DB-9 male adapter. You must provide the USB to DB-9 male adapter.
To connect the device to a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
SSD OK/Fail SSD
slot 1 LED slot 2
Online Master Storage
LED LED LED
Extractor
clip
) port on the Routing Engine module (RE module). To
port, you must supply an additional cable.
AUX
Copyright © 2015, Juniper Networks, Inc.
AUX ) port on