Figure 61: Installing An Sf Module In An Ex9200 Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
202
5.0 V RE
12.0 V
12.0 V RE
Power 2
4.6 V bias MidPlane
11.3 V bias PEM
11.3 V bias FPD
11.3 V bias POE 0
11.3 V bias POE 1
Bus Revision
FPGA Revision
PMBus Expected
device voltage
XF ASIC A
XF ASIC B
NOTE: The output is of an EX9208 switch. The output is similar for all
EX9200 switches.
Figure 61 on page 202 shows installing an SF module in an EX9208 switch. The procedure
is the same for all EX9200 switches.

Figure 61: Installing an SF Module in an EX9200 Switch

SF
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
4969 mV
12258 mV
12239 mV
4840 mV
11195 mV
11234 mV
11176 mV
11214 mV
64
13
Measured Measured
voltage current
1000 mV 1002 mV 11281 mA
1000 mV 997 mV 11015 mA
Calculated
power
11303 mW
10981 mW
. Failure
Copyright © 2015, Juniper Networks, Inc.