Figure 59: Installing An Re Module In An Ex9200 Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation
192
Place one hand underneath the RE module to support it.
4.
Carefully align the sides of the RE module with the guides inside the RE slot on the
5.
SF.
Slide the RE module into the SF module until you feel resistance, and then press in
6.
the faceplate of the RE module until it engages the connectors.
Press both of the ejector handles inward to seat the RE module.
7.
Tighten the screws, one on each side of the RE module using a screwdriver.
8.
Connect the management device cables to the RE module.
9.
The RE module might require several minutes to boot.
After the RE module boots, verify that it is installed correctly by checking the
LEDs on the craft interface. If the switch is operational and the Routing Engine is
RE1
functioning properly, the
steadily instead, remove and install the RE again. If the
the RE is not functioning properly. Contact your customer support representative.
You can use
show chassis routing-engine
Engines.
Figure 59 on page 192 shows installing an RE module in an EX9204 switch. The procedure
is the same for all EX9200 switches.

Figure 59: Installing an RE Module in an EX9200 Switch

Routing
Engine
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Removing an RE Module from an EX9200 Switch on page 193
Switch Fabric Module in an EX9200 Switch on page 29
LED glows steady green. If the
ONLINE
command to check the status of Routing
RE0
LED glows red
FAIL
FAIL LED still glows red steadily,
. Failure
Copyright © 2015, Juniper Networks, Inc.
and