Figure 62: Removing An Sf Module From An Ex9200 Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation
204
Place one hand underneath the SF module to support it, and slide it completely out
6.
of the chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
If you are not replacing the SF module, install a cover panel over the empty slot.
7.
Figure 62 on page 204 shows removing an SF module from an EX9208 switch. The
procedure is the same for all EX9200 switches.

Figure 62: Removing an SF Module from an EX9200 Switch

SF
Ejectors
Installing an SF Module in an EX9200 Switch on page 200
Switch Fabric Module in an EX9200 Switch on page 29
Routing Engine Module in an EX9200 Switch on page 27
Copyright © 2015, Juniper Networks, Inc.