EX9214 Switch Hardware Guide
EX9200-40F-M Line Card
Line Card Models
Line Card Components
58
Installing a Line Card in an EX9200 Switch on page 210
Handling and Storing Line Cards in EX9200 Switches on page 205
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that can
be installed in the line card slots on the front of the switch chassis. The line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions. See
Figure 29: EX9200-40F-M Line Card
This topic describes:
Line Card Models on page 58
Line Card Components on page 58
Table 28 on page 58
shows the model number, description of the line card model, and
the Junos OS release in which the line card was first supported.
Table 28: EX9200-40F-M Line Card
Model
Description
EX9200-40F-M
40-port Gigabit Ethernet line card. All the 40
ports on the line card are Media Access Control
Security (MACsec) capable.
You can use the
show version fpc
switches loaded on the line card.
The EX9200-40F-M line card has:
40 Gigabit Ethernet small form-factor pluggable (SFP) MACsec-capable ports that
can house SFP transceivers. These ports support 1000BASE-T, 10/100/1000BASE-T,
100BASE-FX, 1000BASE-EX, 1000BASE-LH, 1000BASE-LX, and 1000BASE-SX
transceivers.
Line card LED—LED labeled
See
"Line Card LED in an EX9200 Switch" on page
Figure 29 on page
command to see the version of Junos OS for EX Series
OK/FAIL
indicates the status information of the line card.
59.
Copyright © 2015, Juniper Networks, Inc.
58.
Junos OS Release
Required
14.2R1 or later