The Bri Screen - ZyXEL Communications X6004 User Manual

Each field is described in the following table.
Table 22 Configuration > PBX > Server Configuration > Server > FXS
LABEL
FXS
Configuration
Machine ID
Slot
Port
Speaking Volume
Listening Volume
Dial Interval
Country Code
Apply
Reset

6.5 The BRI Screen

Use this screen to configure ISDN BRI interface settings on the X6004. Click Configuration
> PBX > Server Configuration > Server > BRI to view the screen as shown next.
You have to reboot the X6004 manually to apply changes in the Switch Type,
NT/TE mode, or TEI fields.
Figure 115 Configuration > PBX > Server Configuration > Server > BRI
X6004 User's Guide
DESCRIPTION
Use these fields to specify the FXS interface which you want to configure.
Specify the X6004 for which you want to configure FXS settings. This field is only
configurable if you have more than one X6004 working in a ZyStack.
Specify which FXS interface card you want to configure. The cards are identified
by the extension card slot they are installed in. Select one of the slots or select All
to make the settings the same for all FXS interface cards.
Specify the FXS port on the FXS interface card you want to configure.
Select the volume level transmitted by the X6004 from the analog phones
connected to the X6004. -6 is the quietest, and 6 is the loudest.
Select the volume level sent by the X6004 to the analog phones connected to the
X6004. -6 is the quietest, and 6 is the loudest.
Enter the number of seconds the X6004 should wait after you stop dialing
numbers (from FXS extensions) before it makes the phone call.
The signals used by telephone companies to indicate a busy line or an available
line differ by country. You must select the country code for the location of the
X6004. The X6004 can then detect whether the FXS line is in use or available.
Click this to save your changes.
Click this to set every field in this screen to its last-saved value.
Chapter 6 Server
121