The Fxs Screen - ZyXEL Communications X6004 User Manual

Chapter 6 Server
Each field is described in the following table.
Table 21 Configuration > PBX > Server Configuration > Server > FXO
LABEL
FXO
Configuration
Machine ID
Slot
Port
Speaking Volume
Listening Volume
Busy Detect
Country Code
Apply
Reset

6.4 The FXS Screen

Use this screen to configure settings for the analog phones connected to the X6004. To access
this screen, click Configuration > PBX > Server Configuration > Server > FXS.
Figure 114 Configuration > PBX > Server Configuration > Server > FXS
120
DESCRIPTION
Use these fields to specify the FXO interface which you want to configure.
Specify the X6004 for which you want to configure FXO settings. This field is only
configurable if you have more than one X6004 working in a ZyStack.
Specify which FXO interface card you want to configure. The cards are identified
by the extension card slot they are installed in. Select one of the slots or select All
to make the settings the same for all FXO interface cards.
Specify the FXO port on the FXO interface card you want to configure.
Select the volume level transmitted by the X6004 from the phones on your
network via the specified FXO lines. -6 is the quietest, and 6 is the loudest.
Select the volume level transmitted by the X6004 to the phones on your network
for calls via the FXO lines. -6 is the quietest, and 6 is the loudest.
The X6004 listens for a tone to detect if an FXO line has been hung up. This tone
differs by region and it may also differ slightly between carriers. In some cases the
X6004 may mistake background noise for a busy line signal.
This setting defines the number of busy tones the X6004 needs to recognize
before actually considering the line to be busy.
You should select a low value, if you have a good connection. Select a higher
value, if your FXO connection is of lower quality to avoid false hang-ups.
The signals used to indicate a busy line or an available line differ by country. You
must select the country code for the location of the X6004. The X6004 can then
recognize whether the FXO line is in use or available. Select default to reset the
country code value to the factory defaults.
Click this to save your changes.
Click this to set every field in this screen to its last-saved value.
X6004 User's Guide