Table of Contents
Advertisement
Chapter 6 Server
6.3 The FXO Screen
Use this screen to configure settings related to the FXO lines configured on the
X2002. To access this screen, click Configuration > PBX > Server
Configuration > Server > FXO.
Figure 55 Server > FXO
Each field is described in the following table.
Table 22 Server > FXO
LABEL
FXO Setting
Machine ID
Tx Volume
Rx Volume
Busy Detect
Country Code
Apply
Reset
132
DESCRIPTION
Use these fields to specify the FXO interface which you want to
configure.
Indicates the X2002 for which you want to configure FXO settings.
Select the volume level transmitted from the X2002. -6 is the quietest,
and 1 is the loudest.
Select the volume level transmitted to the X2002. -6 is the quietest,
and 6 is the loudest.
The X2002 listens for a tone to detect if an FXO line has been hung up.
This tone differs by region and it may also differ slightly between
carriers. In some cases the X2002 may mistake background noise for a
busy line signal.
This setting defines the number of busy tones the X2002 needs to
recognize before actually considering the line to be busy.
You should select a low value, if you have a good connection. Select a
higher value, if your FXO connection is of lower quality to avoid false
hang-ups.
The signals used to indicate a busy line or an available line differ by
country. You must select the country code for the location of the X2002.
The X2002 can then recognize whether the FXO line is in use or
available. Select default to reset the country code value to the factory
defaults.
Click this to save your changes.
Click this to set every field in this screen to its last-saved value.
X2002 User's Guide
Advertisement
Table of Contents
