Configuring Snmp Trap Receivers - Motorola WS5100 Series Reference Manual

7-16 WS5100 Series Switch System Reference Guide

7.5 Configuring SNMP Trap Receivers

Refer to the Trap Receivers
destination address, port, community and trap version). A new v2c or v3 trap receiver can be added to the
existing list by clicking the
To configure the attributes of SNMP trap receivers:
1. Select Management Access > SNMP Trap Receivers
2. Refer to the following SNMP trap receiver data to assess whether modifications are required.
Destination Address
Port
Community String/
User Name
Trap Version
3. Highlight an existing Trap Receiver and click the
v2c or v3 Trap Receiver.
Edit Trap Receivers as needed if existing trap receiver information is insufficient. You can only modify the
IP address, port and v2c or v3 trap designation within the Edit screen. For more information, see
SNMP Trap Receivers on page
4. Highlight an existing Trap Receiver and click the
of available destinations available to receive SNMP trap information.
Remove Trap Receivers as needed if the destination address information is no longer available on the
system.
screen to review the attributes of existing SNMP trap receivers (including
Add button.
The Destination Address defines the numerical (non DNS name) destination IP
address for receiving traps sent by the SNMP agent.
The Port specifies a destination User Datagram Protocol (UDP) receiving traps.
Enter a Community name specific to the SNMP-capable client that receives the
traps. The community name is public.
The Trap Version defines the trap version (v1/2 or v3) defined by the SNMP-
capable client receiving the trap. A trap designation cannot be modified.
7-17.
from the main menu tree.
Edit button to display a sub-screen used to modify the
Delete button to remove the Trap Receiver from the list
Editing