Motorola WS5100 Series Reference Manual page 42

2-6 WS5100 Series Switch System Reference Guide
Configuration files are tracked by their MD5 checksum. If a file is renamed, it will still have the same md5
sum. Once a file has been loaded it will not be reloaded, even if the local configuration information is
changed.
The requested image file version (if any) is checked against the current version before any attempt is made
to load it. If the requested version is the same as the running version, no action is taken. If the image file
version (embedded in the file header) does not match the expected version, no further action is taken. If the
version has not been specified, the image file header is compared to the local version. If they are the same,
no action is taken.
NOTE: Once the system has been operating for ten minutes, Auto Install is disabled,
though it may still be reconfigured. This is to prevent the system from attempting to re-
install each time a DHCP lease is renewed.
Configuring Auto Install via the CLI
There are three compulsory and four optional configuration parameters.
The compulsory parameters are:
• configuration upgrade enable
• cluster configuration upgrade enable
• image upgrade enable
Optional (only for the static case):
• configuration file URL
• cluster configuration file URL
• image file URL
• expected image version
To set default to no, and the URLs and the version default to "" (blank):
WS5100(config)#show autoinstall
feature
config
cluster cfg
image
expected image version
Enables are set using the
WS5100>en
WS5100#conf t
WS5100(config)#autoinstall image
WS5100(config)#autoinstall config
WS5100(config)#autoinstall cluster-config
After this configuration update, any switch reboot with DHCP enabled on the RON port will trigger an auto
install, provided the DHCP Server is configured with appropriate options.
The "enables" are cleared using the
enabled URL
no --not-set--
no --not-set--
no --not-set--
--not-set--
autoinstall <feature>
no autoinstall <feature>
command: