Motorola WS5100 Series Reference Manual page 294

6-24 WS5100 Series Switch System Reference Guide
6.5.2.3 Editing an Existing Rule
As network and access permission requirements change, existing ACL rules need to be modified to be
relevant with new client access requests.
To modify an existing ACL rule:
1. Select Security
2. Click the Configuration
3. Select an ACL from the ACLs field.
The rules associated with the selected ACL display in the Associated Rules section.
4. Click the Edit
5. Use the Precedence
The rules within an ACL are applied to packets based on their precedence value. Rules with lower
precedence are always applied first.
NOTE: If adding an access control entry to an ACL using the switch SNMP interface,
Precedence
6. Use the Operation
ACL. If the action is to mark, the packet is tagged for priority.
7. Select the Logging
marked based on the criteria specified in the access lists.
8. If mark is selected from within the
enabled. If necessary, select the
receiving priority with this ACL mark designation.
9. From within the
menu.
The source is the source address of the network or host in dotted decimal format. The Source-mask is the
network mask.
10.Use the Source Address
NOTE: If an Extended IP ACL is used, a Destination Wildcard/Mask and Destination
Address are required.
11.Refer to the
messages if something goes wrong in the transaction between the applet and the switch.
12.Click OK to use the changes to the running configuration and close the dialog.
13.Click Cancel
> ACLs from the main menu tree.
tab.
button within the Associated Rules field.
field to modify the precedence (priority) between 1 and 5000.
is a required parameter.
drop-down menu (if necessary) to modify the permit, deny or mark designation for the
checkbox to generate log messages when a packet has been forwarded, denied or
Operations
802.1p (0 - 7)
Filters field, modify (if necessary) the
field to revise (if necessary) the IP address where the packets are sourced.
Status field for the state of the requests made from applet. This field displays error
to close the dialog without committing updates to the running configuration.
drop-down menu, the Attribute to mark
or TOS(0 - 255) checkbox and define the attribute
Source Wildcard/Mask
field becomes
from the drop-down