Viewing Address Resolution - Motorola WS5100 Series Reference Manual

4-8 WS5100 Series Switch System Reference Guide
1. Click the Add
A new Configuration
gateway for routing packets to a defined destination.
2. In the Destination Subnet
3. Enter a subnet mask for the destination subnet in the
The Subnet Mask is the IP mask used to divide internet addresses into blocks known as subnets. A value
of 255.255.255.0 support 256 IP addresses.
4. In the Gateway Address
specified destination subnet. Do not set the gateway address to any VLAN interface used by the switch.
5. Refer to the
messages if something goes wrong in the transaction between the applet and the switch.
6. Click OK to use the changes to the running configuration and close the dialog.
7. Click Cancel

4.2.3 Viewing Address Resolution

The Address Resolution
addresses. To view address resolution details:
1. Select Network
button.
screen displays enabling you to add a new destination subnet, subnet mask and
field, enter an IP address to route packets to a specific destination address.
field, enter the IP address of the gateway used to route the packets to the
Status field for the current state of the requests made from applet. This field displays error
to close the dialog without committing updates to the running configuration.
table displays the mapping of layer three (IP) addresses to layer two (MAC)
> Internet Protocol
Subnet Mask
from the main tree menu.
field.