Motorola WS5100 Series Reference Manual page 293

3. Click the Add button within the Associated Rules field.
4. Use the Precedence field to enter a precedence (priority) value between 1 and 5000.
The rules within an ACL will be applied to packets based on their precedence value. Rules with lower
precedence are always applied first.
NOTE: If adding an access control entry to an ACL using the switch SNMP interface,
Precedence
5. Use the Operation drop-down menu to define a permit, deny or mark designation for the ACL. If the
action is to mark, the packet is tagged for priority.
6. Select the Logging checkbox to generate log messages when a packet has been forwarded, denied or
marked based on the criteria specified in the access lists.
7. If mark is selected from within the
enabled. Select the 802.1p (0 - 7)
with this ACL mark designation.
8. From within the Filters
The source is the address of the network or host (in dotted decimal format). The Source-mask is the
network mask.
9. Use the Source Address
10.Refer to the Status field for the current state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the switch.
11.Click OK to use the changes to the running configuration and close the dialog.
12.Click Cancel to close the dialog without committing updates to the running configuration.
is a required parameter.
Operations drop-down menu, the
or TOS(0 - 255)
field, select a Source Wildcard/Mask
field to enter the IP address where the packets are sourced.
Attribute to mark
checkbox and define the attribute receiving priority
from the drop-down menu.
6-23
Switch Security
field is