Approved Aps (Reported By Aps) - Motorola WS5100 Series Reference Manual

6-6 WS5100 Series Switch System Reference Guide
7. Refer to the
messages if something goes wrong in the transaction between the applet and the switch.
8. Click OK to use the changes to the running configuration and close the dialog.
9. Click Cancel

6.2.2 Approved APs (Reported by APs)

Those access points detected and approved for operation within the switch managed network can be
separately displayed to assess the reporting (detecting) AP, the channel of operation, the last time the AP
was observed on the network and the ESSID. Use this information to assess if an approved access point was
incorrectly defined as approved and requires categorization as an unapproved and disallowed AP.
To review the attributes of allowed APs:
1. Select Security
2. Select the Approved APs (Reported by APs)
3. The Approved APs (Reported by APs)
BSS MAC Address
Reporting AP
Channel
Status field for the current state of the requests made from applet. This field displays error
to close the dialog without committing updates to the running configuration.
> Access Port Intrusion Detection
Displays the MAC Address of each approved AP. These MAC addresses are access
points observed on the network meeting the criteria (MAC and ESSIDs) of allowed
APs.
Displays the numerical value assigned to the radio used with the specific device
MAC Address and SSID listed for this approved AP.
Displays the channel the approved AP is currently transmitting on. If this device is
operating on a channel not frequently used within your network segment, perhaps
the device is correctly defined as an approved AP.
from the main menu.
tab.
table displays the following information: