Motorola WS5100 Series Reference Manual page 109

8. Refer to the Advanced
If using a Syslog server to conduct accounting for the switch, select the Syslog
Accounting Mode
option from the
Config
screen. Use this sub screen to provide the Syslog Server IP address and port for the
Syslog Server performing the accounting function.
If either Hotspot, MAC Authentication or 802.1x EAP have been selected from
within the Authentication field, a
of the screen) allowing the user to define a Primary and Secondary Radius
Accounting Server IP address, port, shared secret password and timeout and retry.
Define these accounting settings as required for the switch.
The default Accounting Mode setting is Off.
Answer Broadcast Select this checkbox to allow the WLAN to respond to probes for broadcast ESS.
ESS
Use Voice Select the Use Voice Prioritization option if Voice is used on the WLAN. This gives
Prioritization priority to voice packets and voice management packets and is supported only on
certain legacy Motorola VOIP phones.
Enable SVP Enabling SVP (Spectralink Voice Prioritization) allows the switch to identify and
prioritize traffic from Spectralink/Polycomm phones.
Secure Beacon Closed system is the secure beacon feature for not answering broadcast SSID.
This option still allows MU to MU communication within the WLAN.
QoS Weight Sets the Quality of Service weight for the WLAN. The default value for the weight
is 1. WLAN QoS will be applied based on the QoS weight value with the higher
values given priority.
MU to MU Traffic Allows frames from one MU (where the destination MAC is of another MU) are
switched to a second MU. Use the drop-down menu to select one of the following
options:
• Drop Packets – This restricts MU to MU communication based on the WLAN's
configuration
• Allow Packets – This allows MU to MU communication based on the WLAN's
configuration
• Forward through switch – The frames from the MU are switched out to the
wired network (out of the switch). Another upstream device decides whether
the frame should be sent back to the second MU, and if so, it sends the frame
back to the switch and is switched out just like any other frame on the wire.
MU Idle Time Set the MUs idle time limit in seconds.
Access Category Displays the Access Category for the intended traffic. The Access Categories are
the different WLAN-WMM options available to the radio.
The Access Category types are:
• Automatic/WMM – Optimized for WMM
• Voice – Optimized for voice traffic. Voice packets receive priority.
• Video – Optimized for video traffic. Video packets receive priority.
• Normal – Optimized for normal traffic
• Low – Optimized for background traffic
field for the following information:
Accounting Mode
button is enabled on the bottom of the Network > Wireless LANs > Edit
Radius Config
drop-down menu. Once selected, a
button is enabled (on the bottom
4-27
Network Setup
Syslog