Removing And Reinstalling The Fixing Separation Claw (Upper) Unit And Fixing Separation Claws (Upper) - Konica Minolta 7155 Service Manual

(4) Remove the rear lamp harness from the two har-
ness guide to remove the Faston terminal.
Harness guides
Lamp fixing plate (rear)
(5) Pull out the fixing heater lamp (L4) from the front
side of the fixing lower roller.
Fixing heater lamp (L4)
(6) Reinstall the above parts following the removal
steps in reverse.
Caution: When installing the lamp, pay atten-
tion to its orientation. The lamp cannot
be installed properly if it is facing the
opposite direction.
[7] Removing and Reinstalling the Fixing
a.
(1) Remove the fixing unit.
(2) Remove the fixing unit front cover.
(3) Remove the web cover.
(4) Remove the screw to detach the fixture.
(5) Remove the fixing separation claw (upper) unit
Faston terminal
(6) Remove the screw to remove the upper separa-
(7) Remove six springs attached to the fixing sepa-
(8) Remove six fixing separation claws (upper).
3-O-5
Separation Claw (Upper) Unit and
Fixing Separation Claws (Upper)
Procedure
Fixing separation claw
(upper) unit
Fixture
tion claw support shaft from the fixing separation
claw (upper) unit.
Caution: Be careful when removing the shaft
because it bends easily.
ration claw (upper) unit.
Separation claw
(upper) support shaft
Screw
FIXING UNIT
Screw
Spring
Fixing separation
claw (upper) (6)