CLUTCH RELEASE CYLINDER 6
1. Pull out the push rod and boot.
2. Remove the piston and piston cup by blowing com
pressed air through the clutch pipe installation hole.
Caution
When doing so, use a rag to prevent the pis
ton and piston cup assembly from projecting
out.
86U06X-023
3. Remove the return spring.
4. Remove the following parts if necessary:
(1) Bleeder cap
(2) Bleeder screw
(3) Steel ball
86U06X-024
INSPECTION
After cleaning all parts, check the following points.
Replace any parts with new parts if necessary. Note
that rubber parts should be cleaned with clutch fluid.
1. Wear or damage of cylinder wall and piston.
2. Weakness of return spring.
3. Wear or damage of piston cup.
76U06X-029
ASSEMBLY
1. Install the following parts:
(1) Steel ball
(2) Bleeder screw
(3) Bleeder cap
2. Install the return spring.
3. Install the new piston and piston cup assembly.
Caution
a) A new piston and piston cup assembly must
be used.
b) Make sure the return spring and piston cup
assembly are as illustrated.
626, MX-6 Revised 10/87
6 - 1 1