5 STARTER
5 -3 0
Installation of Brush Holder
Install the brush holder assembly and rear cover and
align the through bolts.
7BU05X-048
CHECKING OPERATION
Magnetic Switch
Make the following tests:
Pull-out test
1. Check that the pinion is pulled out when 12V is con
nected to the S terminal and the body is grounded.
86U05X-038
2. Measure the pinion gap while the pinion is pulled
out.
Specification: 0.5—2.0 mm (0.02—0.08 in)
3. Adjust the pinion gap with an adjust washer (drive
housing front cover—magnetic switch) if it is not
within specification.
7BU05X-050
Return test
1. Disconnect the motor wire from the M terminal, and
then connect the battery power to the M terminal
and ground the body.
2. Pull out the overrunning clutch with a flat-tip screw
driver. Check that the overrunning clutch returns
to its original position when released.