Mazda 626 MX-6 Workshop Manual page 470

Rechecking of Bearing Preload
1. Remove the SST and transaxle.
2. Remove the bearing outer races from the trans­
axle case.
3. Install the primary and secondary adjust shims, di­
aphragm springs and bearing outer races to the
case as shown in the figure.
4. Install the differential adjust shim(s) and bearing out­
er race to the case.
5. Install the primary and secondary bearing outer
races to the clutch housing.
86U07A-193
6. Install the primary shaft gear assembly and the
differential assembly.
7. Install the transaxle case and tighten the specified
torque.
Tightening torque: 37—52 N-m
76G07A-647
8. Connect the SST.
9. Check that the preload is within the specified range.
Primary shaft: 0.1—0.25 N-m
49 B017 102
Turbo
Differential: 1.4—2.0 N-m
Non-Turbo
76G07A-620
10. Check secondary shaft preload in the same man­
ner as that of the primary shaft.
Secondary shaft: 0.2—0.4 N-m
626, MX-6 Revised 10/87
ASSEMBLY
(3.8—5.3 m-kg, 27—38 ft-lb)
(1.0—2.5 cm-kg, 0.87—2.17 in-lb)
(14—20 cm-kg, 12.1—17.3 in-lb)
(2.0—4.0 cm-kg, 1.72—3.46 in-lb)
7A
7A-73