Engine harness connector
Install the engine harness connectors.
ON-VEHICLE MAINTENANCE (CYLINDER HEAD)
Distributor
1. Apply engine oil to the O-ring, and position it on
the distributor.
2. Apply engine oil to the blade.
3. Install the distributor into the rear housing.
4. Loosely tighten the distributor mounting bolt.
86U01X-039
Steps After Installation
1. Fill the radiator with the specified amount and type
of coolant.
2. Perform the necessary engine adjustments. (Re
fer to TUNE-UP PROCEDURE.)
86U01X-041
1. Knock sensor
(turbo)
2. EGR position
sensor (turbo)
3. Water thermo
switch
4. Injector
5. Engine ground
6. Oxygen sensor
7. Crank angle sen
sor (turbo)
8. Solenoid valve
(idle speed
control)
9. Idle switch
10. Throttle sensor
11. Water thermo
sensor
12. Waste gate sole
noid valve
(turbo)
13. Heat gauge unit
14. Water thermo
switch
86U01X-040
1
1 -2 1