\>
3. Warm up the engine and run it at idle.
4. Connect a vacuum pump to the valve and apply
vacuum.
5. Check that the engine runs roughly or stalls at more
than the specified vacuum.
Specification:
40—60 mmHg (1.6—2.4 inHg)
6. If not correct, replace the EGR control valve.
86U04B-116
Vacuum Chamber
1. Disconnect the vacuum hoses from the vacuum
chamber, and remove it.
2. Connect the vacuum pump to the vacuum cham
ber as shown.
3. Apply vacuum and check that no vacuum is held.
4. If not correct, replace the vacuum chamber.
5. Connect the vacuum pump to the vacuum cham
ber as shown.
6. Apply vacuum and check that vacuum is held.
7. If not correct, replace the vacuum chamber.
86U04B-118
4B
EGR SYSTEM
4B-95
1