Starter Removal; Starter Disassembly - Mazda 626 MX-6 Workshop Manual

5 STARTER
DISASSEMBLY
1. Magnetic switch
2. Plunger and spring
3. Rear housing
4. Brush holder assembly
5. Armature
Caution
Do not strike the yoke with a hammer, drop it or put it in a vise when disassembling the
starter.
REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect the wiring from the starter.
3. Raise the front of the vehicle and support it with
safety stands.
4. Remove the intake manifold bracket.
5. Remove the starter bolts.
6. Draw out the starter from lower side of the vehicle.
Note
Remove the lowest starter bolt last.
86U05X-032
6. Ball
7. Planetary gear
8. Drive housing front cover
9. Lever
10. Drive pinion
11. Overrunning clutch
12. Internal gear
13. Yoke assembly
14. Gear shaft
86U05X-083