1
ASSEMBLY (CYLINDER BLOCK)
1—64
3. Apply engine oil to the oil seal lip.
4. Remove any dirt or other material from the con
tact surfaces.
5. Apply a continuos bead of silicon sealant to the
contact surface of the oil pump.
Caution
Do not allow any sealant to get into the oil
hole.
86U01X-133
6. Install a new O-ring into the pump body.
7. Install the oil pump.
Tightening torque:
Bolt A:
19—25 Nm (1.9—2.6 m-kg, 14—19 ft-lb)
Bolt B:
37—52 Nm (3.8—5.3 m-kg, 27—38 ft-lb)
8. Remove any sealant which has been squeezed
out.
86U01X-134
Stiffener
1. Remove any dirt or other material from the con
tact surface.
2. Apply a continuous bead of silicone sealant to the
stiffener along the inside of the bolt holes, and over
lap the ends.
3. Install the stiffener.
Tightening torque:
8—11 N m (80—110 cm-kg, 69—95 in-lb)
86U01X-135
Oil Strainer
Install the oil strainer and a new gasket.
Tightening torque:
8—12 N m (80—120 cm-kg, 69—104 in-lb)
86U01X-136