-
-
It-
i
Revised 5/91
ASSEMBLY (CYLINDER HEAD) 1
3. Apply engine oil to the oil seal lip.
4. Install the front housing and a new gasket.
Tightening torque:
19—25 Nm (1.9—2.6 m-kg, 14—19 ft-lb)
86U01X-156
Rear Housing
Install the rear housing and a new gasket.
Tightening torque:
19—25 Nm (1.9—2.6 m-kg, 14—19 ft-lb)
86U01X-157
Cylinder head cover and gasket
1. Clean out used silicon sealant from the gasket and gasket
groove.
new
2. Apply
3. Apply silicon sealant to the shaded areas shown in the figure.
4. Install the cylinder head cover.
Tightening torque:
6—8 N m (60—80 cm-kg, 52—69 in-lb)
86U01X-158
silicon sealant to the back of tie gasket.
(1988 626/MX-6) 1-71