Mazda 626 MX-6 Workshop Manual page 133

4 A
TROUBLESHOOTING WITH SST
4 9 H 0 1 8 9A1
Test connector: Green (1 pin)
Ignition switch: ON
for six seconds
2. Connect the SST to the check connector.
3. Ground the test connector (Green, 1-pin) with a
jumper wire.
86U04A-015
4. Turn the ignition switch ON, but do not start the
engine for six seconds.
5. Start and warm up the engine, then run it at 2,000
rpm for two minutes.
. Verify that no code numbers are displayed.
6
86U04A-016