Transaxle Control Removal And Installation - Mazda 626 MX-6 Workshop Manual

7A
INSTALLATION
TRANSAXLE CONTROL
REMOVAL AND INSTALLATION
1. Jack up the vehicle and support it with safety stands.
2. Remove in the sequence shown in the figure.
3. Install in the reverse order of removal.
1. Change lever knob
2. Assist boot
3. Mounting rubber boot
4. Bolts and nuts
5. Change control rod
6. Bracket installation nuts
Note
Apply a coat of grease (lithium base, NLGI No. 2) to the change lever ball, the ball seats,
and each joint.
7A—84
7. Nut and washer
8. Extension bar bracket as­
sembly and gasket
9. Bushing
10. Pipe
11. Change lever
6iG07x-i65
86U07A-230
12. Spring
13. Ball seat (upper)
14. Bushings
15. Boot
16. Holder
17. Ball seat (lower)
18. Extension bar