Table of Contents
Advertisement
6 AIR BLEEDING
49 0259 770B
t
6 -1 2
4. Install the following parts:
(1) Push rod
(2) Boot
76U06X-031
INSTALLATION
1. Install the release cylinder.
2. Tighten the installation bolts.
Tightening torque:
19—26 N-m (1.9—2.6 m-kg, 14—19 ft-lb)
3. Tighten the clutch pipe flare nut securely with the
SST
After installation
1. Perform air bleeding.
2. Verify that there is no leakage from the hydraulic
circuit.
3. Perform a road test.
86U06X-026
AIR BLEEDING
The clutch hydraulic system must be bled to remove
air that entered when the pipes were disconnected.
This bleeding is done as described below.
Note
a) The fluid in the reserve tank must be main
tained at the 3/4 level or higher during air
bleeding.
b) Use only the specified fluid type. (Refer to
page 6—3)
c) Be careful not to spill clutch fluid onto a
86U06X-027
painted surface.
1. Remove the bleeder cap, and attach a vinyl hose
to the bleeder screw.
2. Place the other end of the vinyl tube in a glass con
tainer of the appropriate capacity.
3. Slowly pump the clutch pedal several times by
hand.
4. While the clutch pedal is depressed, loosen the
bleeder screw to let fluid and air escape.
Then close the bleeder screw.
5. Repeat step 3 and 4 until no more air bubbles are
in the fluid.
6. Check for correct clutch operation.
v
Advertisement
Table of Contents
Troubleshooting
