Mazda 626 MX-6 Workshop Manual page 449

7A
DISASSEMBLY
STEP 3
Disassemble in the sequence shown in the figure referring to the disassembly note for the specially
marked part.
Note
a) Replace the bearings with new ones whenever they are disassembled.
b) Before disassembly, check the thrust clearance of all gears. (Refer to page 7A—65)
1. Bearing inner race
2. 4th gear
3. Needle bearing
4. Gear sleeve
5. Ball
6. Synchronizer ring
7. Clutch hub assembly
(3rd/4th)
8. Synchronizer ring
9. 3rd gear
10. Needle bearing
0
( )
11. Bearing inner race
12. Primary shaft
13. Bearing inner race
14. Secondary 4th gear
15. Gear sleeve
16. Secondary 3rd gear
17. 2nd gear
18. Needle bearing
19. Gear sleeve
20. Ball
86U07A-130
21. Synchronizer ring
22. Clutch hub assembly
(1st/2nd)
23. Synchronizer ring
24.1st gear
25. Needle bearing
26. Thrust washer
27. Bearing inner race
28. Secondary shaft
29. Reverse gear