Secondary Shaft Adjust Shim - Mazda 626 MX-6 Workshop Manual

7A
ASSEMBLY
Thickness (Shaft gears)
0.20 (0.008)
0.25 (0.010)
0.30 (0.012)
0.35 (0.014)
0.40 (0.016)
0.45 (0.018)
7A-38
6. To seat the bearings, mount the SST (bars) on
parts ® a n d (§)of the selector, and then turn the
selector so the gap is widened.
Then turn it in the reverse direction until the gap
is eliminated.
86U07A-255
7. Manually expand the selector until the selector no
longer turns by hand.
Note
Check that each shaft turns smoothly.
8. Use a feeler gauge and measure the gap in the
selector.
Note
Measure the gap around the entire circumfer­
ence of the selector.
86U07A-256
9. Take the maximum reading and determine the
shim to be used as follows:
< Primary shaft adjust shim >
• Subtract the diaphragm spring thickness (0.70
• Select the closest thinner shim from the table.
Example
1.22 mm (0.0480 in) - 0.70 mm (0.0276 in)
= 0.52 mm (0.0204 in)
Shim: 0.50 mm (0.020 in)
< Secondary shaft adjust shim >
mm (in)
• Subtract the diaphragm spring thickness (0.70
0.50 (0.020)
• Select the closest thinner shim from the table.
0.55 (0.022)
0.60 (0.024)
Example
1.22 mm (0.0480 in) - 0.70 mm (0.0276 in)
0.65 (0.026)
= 0.52 mm (0.0204 in)
0.70 (0.028)
Shim: 0.55 mm (0.022 in)
Note
Use a maximum of two shims.
86U07A-258
626, MX-6 Revised 10/87
mm, 0.0276 in) from the gap determined in the
step 8.
mm, 0.0276 in) from the gap determined in the
step 10.