Mazda 626 MX-6 Workshop Manual page 408

7A
ON-VEHICLE MAINTENANCE
7 A—10
Tap the new oil seal into the transaxle case with
the SST.
Note
a) Tap in until the oil seal installer contacts the
case.
b)Coat the oil seal lip with transaxle oil.
Replace the driveshaft end clip with a new one.
Insert the clip with the gap at the top of the groove.
Install the driveshaft as follows:
(1) Pull the front hub outward, then fit the driveshaft
into the transaxle.
(2) Insert the driveshaft into the transaxle by push­
ing on the wheel hub assembly.
Note
a) Be careful not to damage the oil seal.
b) After installation is finished, pull the front
hub slowly outward to check that the
driveshaft is held securely by the clip.
Install the lower arm ball-joint to the knuckle, and
tighten the clinch bolt.
Tightening torque:
43—54 N m (4.4—5.5 m-kg, 32—40 ft-lb)
Install the tie-rod end and new cotter pin.
Tightening torque:
29—44 N m (3.0—4.5 m-kg, 22—33 ft-lb)