Mazda 626 MX-6 Workshop Manual page 419

STEP 3
Disassemble in the sequence shown in the figure, referring to the disassembly note for the specially
marked parts.
Note
a) Replace the bearings with new ones whenever they are disassembled.
b) Before disassembly, check the thrust clearance of all gears. (Refer to page 7A—32.)
1. Shift fork (3rd and 4th
gears)
2. Interlock sleeve
3. Spring pin
4. Control end
5. Shift fork (1st and 2nd
gears)
6. Spring pin
7. Control lever
8. Control rod
9. Bearing outer race
10. 4th gear
11. Retaining ring
12. 3rd gear
13. 2nd gear
14. Synchronizer ring
15. Retaining ring
16. Clutch hub assembly
17. Synchronizer spring
18. Synchronizer key
19. Clutch hub
20. Clutch hub sleeve (reverse
gear)
21. Synchronizer ring
22. 1 st gear
23. Bearing inner race
24. Secondary shaft
25. Bearing inner race
DISASSEMBLY
86U07A-045
26. 4th gear
27. Synchronizer ring
28. Retaining ring
29. Clutch hub assembly (3rd
and 4th gears)
30. Synchronizer spring
31. Synchronizer key
32. Clutch hub
33. Clutch hub sleeve
34. Synchronizer ring
35. 3rd gear
36. Bearing inner race
37. Primary shaft
7A
7 A—21