Mazda 626 MX-6 Workshop Manual page 439

8. Install the new breather.
9. Install the new change rod oil seal.
86U07A-106
10. Install the change rod (1), the boot (2), the spring
(3), the reverse gate (4), and selector (5), as shown.
11. Install the new roll pin.
86U07A-107
12. Install the change arm.
Tightening torque: 12—14 N m
(120—140 cm-kg, 104—122 in-lb)
13. Install the guide plate.
Tightening torque:
(A) 8— 11 N m
(80—115 cm-kg, 69—100 in-lb)
(§) 22—33 N m
(2.25—3.35 m-kg, 16—25 ft-lb)
14. Install reverse lever, and reverse lever shaft.
15. Install the new roll pin.
16. Install the speedometer driven gear assembly.
7A
ASSEMBLY
7A-41