4A
EEC SYSTEM
4A-76
14. Disconnect the evaporation hose from the evapo
ration pipe.
15. Connect the vacuum pump to the evaporation
pipe.
16. Operate the vacuum pump and verify that no vacu
um is held.
17. If vacuum is held, check the evaporation pipe for
clogging.
No. 1 Purge Control Valve
1. Blow through the purge control valve from port A
and check that air does not flow.
2. Connect a vacuum pump to the purge control
valve.
3. Apply 110 mmHg (4.33 InHg) vacuum, and blow
through port A again; air should flow.
No. 2 Purge Control Valve
1. Disconnect vacuum hose B from the evaporation
pipe.
2. Blow through the hose and verify that air flows
freely.
Vacuum Switch Valve
1. Remove vacuum switch valve.
2. Connect a vacuum pump to the valve.
3. Blow through the valve from port A and verify that
air comes out of port B when vacuum is applied.
Specified vacuum:
66—106 mmHg (2.6—4.2 inHg)
86U04A-146