5 ALTERNATOR
5—14
4. Replace the front bearing
Using a socket which exactly fits on the outer race
of the bearing, carefully press in the bearing. Use
a hand press or a vise.
86U05X-076
5. Replace the rear bearing
The bearing can be pulled off by using a bearing
puller.
When it is pressed on, press it on so that the groove
at the bearing circumference is at the slip ring side.
Bearing puller
86U05X-086
6. Remove the nut of the B terminal and the insula
tion bushing.
7. Remove the rectifier holding screws and the brush
holder holding screw.
8. Separate the rear bracket and the stator.
86U05X-077
9. Use a soldering iron to remove the solder from the
rectifier and the stator leads, and then remove the
1C regulator.
Caution
Disconnect quickly, use the soldering iron no
more than about 5 seconds because the rec
tifier may be damaged if it is overheated.
86U05X-087