Mazda 626 MX-6 Workshop Manual page 479

7A
INSTALLATION
7 A—82
19. Install the stabilizer bar control links as follows.
(1) Install the stabilizer bar control link.
(2) Adjust protrusion to 20.1 mm (0.79 in)
(3) Tighten bolt to specified torque.
Tightening torque: 16—23 N-m
(1.6—2.3 m-kg , 12—17 ft-lb)
20. Install the tie-rod ends and new cotter pin.
Tightening torque: 29—44 N-m
(3.0—4.5 m-kg, 22—33 ft-lb)
21. Install the splash shields.
Tightening torque: 8—11 N-m
(80—110 cm-kg, 69—95 in-lb)
22. Install the front wheels.
Tightening torque: 88—118 N-m
(9.0—12.0 m-kg, 65—87 ft-lb)
23. Install the grounds to the transaxle case.
Tightening torque: 8—11 N-m
(80—115 cm-kg, 69—100 in-lb)
24. Connect the speedometer cable.