Mazda 626 MX-6 Workshop Manual page 483

7A
TRANSAXLE CONTROL
7A—86
Gear Shift Lever Ball
Apply grease to the ball seat surface, and install the
upper and lower ball seat, holder, and boot.
Note
Apply grease to all joints.
Spring
Make sure that the hooked part of the spring is
properly seated in the bracket groove, as shown in
the figure.
Bracket Cavity
Put grease in the bracket cavity.
63U07A-157
Change Control Rod
Install the change control rod so that its relationship
with the shift lever is as shown in the figure.
Tightening torque:
16—22 Nm (1.6—2.3 m-kg, 12—17 ft-lb)
v