Alternator Assembly; Front Bracket And Rotor; Brush Lifting; Rear Bearing Installation (Alternator) - Mazda 626 MX-6 Workshop Manual

1988
Table of Contents

Advertisement

Stopper spring
Rear bearing
86U05X-026
86U05X-027
86U05X-028
4BG05X-054
ASSEMBLY
Assemble in the reverse order of disassembly, refer­
ring to assembly note.
Assembly Note
Stopper spring installation
1. Fit the stopper spring into the eccentric groove of
the rear bearing circumference.
2. Check that the protruding part of the spring is fitted
into the deepest part of the groove.

Front bracket and rotor

When assembling the front bracket and rotor, tight­
en the locknut to the specified torque.
Tightening torque:
49—88 Nm (5—9 m-kg, 36—65 ft-lb)

Brush lifting

1. Before assembly, use a finger to hold the brushes
into the brush holder; then pass a wire (< /> 2 mm,
40—50 mm, </>0.08 in, 1.6—2.0 in) through the
hole shown in the figure.
2. Secure the brushes in position.
Note
Be sure to remore wire after assembly is com­
pleted.
Rear bearing installation
1. Heat the rear bracket.
2. Press the rear bearing into the rear bracket.
3. Check that the rotor turns easily.
ALTERNATOR 5
5 -1 9

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents