Table of Contents
Advertisement
No-Load Test
1. After adjusting the pinion gap, form a test circuit
with a voltmeter and an ammeter.
Note
Use heavy gauge wires and tighten each ter
minal fully.
2. Close switch K to run the starter.
3. Check for the following:
Voltage
(V)
Current
(A)
Gear shaft speed
(rpm)
4. If any abnormality is noted, check for the cause
according to ''Inspection" .
INSTALLATION
Install in the reverse order of removal.
Note
When installing the starter, tighten the bolts
to the specified torque.
Tightening torque:
Bolts............. 37—52 Nm
(3.8—5.3 m-kg, 27—38 ft-lb)
B terminal.....9.8—11.8 N-m
(1.0—1.2 m-kg, 87—104 in-lb)
Intake manifold bracket bolt.....
37—52 Nm (3.8—5.3 m-kg, 27—38 ft-lb)
Nut.....
19—25 Nm (1.9—2.6 m-kg, 14—19 ft-lb)
STARTER 5
11.0
90 max.
3,000 min.
5-31
Advertisement
Table of Contents
Troubleshooting
