Clutch Master Cylinder; Clutch Slave Cylinder; Clutch Cable; Glc Wagon Clutch Cable Assembly - Mazda 1983 RX7 Service Manual

in thrust direction. Replace if bearing feels rough or noisy. Inspect
release fork for cracks or bends. Replace if necessary.
3) Lightly apply molybdenum grease to clutch component
contact areas and sliding surfaces. To complete installation, reverse
removal procedures.

CLUTCH MASTER CYLINDER

Removal & Installation (Except GLC Wagon)
Disconnect hydraulic line and mount nuts from master
cylinder. Unhook clutch pedal from push rod. Remove cylinder. To
install, reverse removal procedure and bleed hydraulic system.

CLUTCH SLAVE CYLINDER

Removal & Installation (Except GLC Wagon)
Raise and support vehicle. Disconnect fluid hose and plug.
Remove slave cylinder-to-clutch housing mount nuts. Detach cylinder.
To install, reverse removal procedure and bleed hydraulic system.

CLUTCH CABLE

Removal & Installation (GLC Wagon)
1) Loosen clutch release cable lock nuts at stop ring on
engine side of firewall. Pull inner cable toward clutch pedal.
Disconnect inner cable from pedal assembly.
2) Pull and remove cable through stop ring from engine side
of firewall. Disconnect inner cable at release lever. Remove retaining
clip, pull outer cable and remove from clutch housing bracket. See
Fig. 2.
Fig. 2:

GLC Wagon Clutch Cable Assembly

After installation, adjust the clutch cable to specification.
CLUTCH
Article Text (p. 3)
1983 Mazda RX7
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Sunday, August 26, 2001 06:33PM