Starting System; Starter Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

Hide thumbs Also See for Mazda6:

Table of Contents

• When the battery cables are connected, touching the vehicle body with starter terminal B will

generate sparks. This can cause personal injury, fire, and damage to the electrical components.

Always disconnect the battery negative cables before performing the following operation.

1. Disconnect the negative battery cable.

2. Remove the plug hole plate. (L8, LF, and L3 engine models)

3. Remove the engine cover. (MZR-CD (RF Turbo) engine model) (See

INSTALLATION.)

4. Remove the air cleaner assembly. (L8, LF, and L3 engine models).

5. Remove the under cover.

6. Remove the oil filter and oil cooler component with the cooling hose connected. Position the oil filter and oil

cooler component so that it is out of the way. (L3 engine model (4WD))

7. Remove the solenoid valve assembly with the vacuum hose and the connector connected. Position the

solenoid valve assembly so that it is out of the way. (MZR-CD (RF Turbo) engine model)

8. Remove the release cylinder with the oil pipe connected. Position the release cylinder so that it is out of the

9. Remove in the order indicated in the table.

10. Install in the reverse order of removal.

STARTING SYSTEM

B2–9 TIMING BELT REMOVAL/

A6E471418400202

Table of Contents