Removing a Front-Mounted Switch from a Two-Post Rack
Removing a front-mounted Summit X480 switch from a rack requires two people to maneuver the
switch and disconnect the mounting hardware.
To remove a front-mounted switch:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Verify that all power supplies have been removed from the switch.
3 Support the switch while you remove the rack-mounting screws holding the front mounting brackets
in place against the rack post
4 Slide the switch out of the rack.
Figure 244: Removing a Front-Mounted Switch from a Two-Post Rack
Removing a Switch from a Four-Post Rack
Removing the Summit X650 switch from a cabinet or rack requires two people to maneuver the switch
and disconnect the mounting hardware.
To remove the Summit X650 series switch from a cabinet or four-post rack:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Verify that all power supplies have been removed from the switch.
3 Support the front of the switch while you remove the front rack mounting screws
4 Carefully slide the switch forward out of the cabinet and off the rear mounting brackets.
Summit Family Switches Hardware Installation Guide
(Figure
244).
SH_130
(Figure
245).
287