Section 7-Arms; Installing/Removing Flip Back Armrests; Installing; Removing - Invacare 3G Storm Series Owner's Operator And Maintenance Manual

SECTION 7—ARMS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.

Installing/Removing Flip Back Armrests

Make sure the flip back armrest release and height adjustment levers are in the
locked position before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 7.1 on page 80.
NOTE: Flip back armrest release lever must be in the unlocked (horizontal) position when placing
the armrest into the arm sockets.

Installing

1. Visually inspect to ensure flip back armrest release lever is in the unlocked
(horizontal) position.
2. Slide the flip back armrest into the arm sockets on the seat frame.
3. Install the quick release pin through the rear arm socket and flip back armrest.
4. Lock the flip back armrest by pressing the flip back armrest release lever into the
locked (vertical) position.
5. Repeat STEPS 1-4 for the opposite flip back armrest.

Removing

1. Unlock the flip back armrest by positioning the flip back armrest release lever into the
unlocked (horizontal) position.
2. Remove the quick release pin that secures the flip back armrest to the rear arm socket.
3. Pull up on the flip back armrest and remove the armrest from the arm sockets.
4. Repeat STEPS 1-3 for the opposite flip back armrest, if necessary.
Part No 1134791
All manuals and user guides at all-guides.com
WARNING
WARNING
79
SECTION 7—ARMS
3G Storm Series® Wheelchairs