Fujitsu iScanner fi-6010N Operator's Manual page 510

Screen
Others
474
Message
An error has occurred. Try turning the
power off and back on again. The
administrator should contact the
FUJITSU scanner dealer or an autho-
rized FUJITSU scanner service pro-
vider for help.
[alphanumeric eight digits]
An error has occurred. The system
must be restarted. Any buffered jobs
will be canceled. If problem persists,
the administrator should contact a
FUJITSU scanner dealer or an autho-
rized FUJITSU scanner service pro-
vider for help.
[alphanumeric eight digits]
An error has occurred. The system
must be restarted. Any buffered jobs
will be canceled. After restarting the
system, if the same error occurs, it
may be due to a scanner failure. In this
case, remove any documents that have
been fed into the scanner, disconnect
and reattach the power cord, and
restart the system again. If problem
persists, the administrator should con-
tact a FUJITSU scanner dealer or an
authorized FUJITSU scanner service
provider for help. [alphanumeric eight
digits]
Action
Try the following:
• If the scanner does not restart
automatically, press the [Shut-
down] button on the "Login"
screen to turn the power off, and
turn the power back on again to
restart the scanner.
• If the error status persists after
the scanner is restarted, press
the [Shutdown] button on the
"Login" screen, disconnect the
AC cable from the scanner to
turn the power off, wait for at
least ten seconds, then recon-
nect the AC cable and try turn-
ing the power back on again. If
the error status persists, contact
your FUJITSU scanner dealer
or an authorized FUJITSU scan-
ner service provider.
If the problem persists, the admin-
istrator should contact a FUJITSU
scanner dealer or an authorized
FUJITSU scanner service pro-
vider.
If the problem persists, the admin-
istrator should contact a FUJITSU
scanner dealer or an authorized
FUJITSU scanner service pro-
vider.