Fujitsu iScanner fi-6010N Operator's Manual page 499

Screen
Roller Clean- Scanner top cover is closed. Open the
ing cover and try again.
Press the keyboard [C] key to step the
feed rollers forward. Press the [OK]
button after the feed rollers have been
cleaned.
Shutdown Shutdown will occur after all jobs fin-
ish. Please wait...
Scan Test Document not found. Load a docu-
ment into the ADF, making sure the
side guides are adjusted correctly and
try again.
Feed Error: Document(s) may not
match the set paper size, ADF may
have grabbed more than one sheet, or
documents may not be suitable for
scanning. Remove the documents
from the ADF, check them and try
again. If problem persists, consult the
manual.
Paper jam has occurred. Remove the
documents from the ADF and try
again.
Message
fi-6010N Network Scanner Operator's Guide
Action
Open the top cover to clean the
feed rollers, and try again. For
details, refer to "7.2.1 Cleaning the
ADF" (page 358).
Clean the rollers, and then press
the [OK] button.
Operations cannot be carried out
while the scanner is shutting down.
The scanner will shutdown auto-
matically. Please wait.
Load the document into the ADF
paper chute, and try again. Load
the document to prevent any space
between the side guides and the
edges of the documents.
For details, refer to "6.1 Loading
Documents" (page 250).
Press the ADF release button to
open the top cover, and remove the
documents from the ADF. If more
than one sheet has been fed, reset
the document and try again.
Check that the actual document(s)
size matches the paper size speci-
fied in the "Paper Size" screen. If
not, specify the paper size again.
For details, refer to "6.8.3 Paper
Size" (page 312).
Try the following:
• Remove the documents from
the ADF.
• Remove the pages which were
not scanned correctly.
E
463