Fujitsu iScanner fi-6010N Operator's Manual page 213

3. Enter the job menu name.
This may be up to 64 characters long.
4. Select the job button position, and select the [Edit] button.
⇒
The "Job Button Settings" window appears.
5. Enter the job button name.
This may be up to 32 characters long.
6. In the [Job Button Pixmap] drop-down list box, select the job button pixmap.
When Job button image is selected, a job button pixmap appears in the right side of the [Job
Button Color] drop-down list box, allowing to check the display image of the button while
making a selection.
7. Set whether to start up the Add-in module.
To start up the Add-in module when the job button is selected, select the [Use button to start
Add-in module] checkbox.
If this checkbox is selected, the Add-in module is assigned to the job button, rather than the
job sequence. The "Job Button Name" and "Job Button Pixmap" are ignored. The button
specified by the Add-in module appears in the Job Menu.
Even if the checkbox is selected, if the Add-in module is not installed in
ATTENTION
a scanner, the target job menu button will not be shown on the screen.
4.11 Setting Job Features
fi-6010N Network Scanner Operator's Guide
4
177