Checking The Ntp Server Settings By Synchronizing The System Time - Fujitsu iScanner fi-6010N Operator's Manual

■ Checking the NTP server settings by synchronizing the system
time
On the "NTP Server" screen, press the [Sync Time] button to check if the system time can be syn-
chronized.
After pressing the [Sync Time] button, follow each action described below according to the mes-
sage that is shown.
Message
System time has been suc-
cessfully synchronized.
System time synchronization
failed.
8.3 Network Connection Troubleshooting
None
Try the following:
•
Check the specified NTP server IP address, host name, or
FQDN for mistakes, and correct them.
•
Check the network path between to the NTP server for prob-
lems.
•
The NTP server may be busy. Wait a short time before trying
again to synchronize the system time. If that does not work, the
specified server may not be an NTP server, so try a different
NTP server.
•
The specified NTP server cannot provide a trusted date and
time. It attempted to acquire the date and time from a higher
level NTP server, but failed. Try a different NTP server or have
the network administrator investigate.
•
Check that the time is correct.
If the time is incorrect, adjust the date/time, and try again.
•
Refer to "4.6.5 Setting the Date/Time" (page
date/time, and try again.
fi-6010N Network Scanner Operator's Guide
Action
59), adjust the
8
391