Replacing The Pf_Enc Assembly And Pf Scale Assembly - MUTOH Rockhopper II series Maintenance Manual

4.5.2. Replacing the PF_ENC assembly and PF scale assembly

Notes :
Step 1 :
Remove the PF_ENC assembly connector.
Step 2 :
Remove the 2 screws fixing the PF encoder installation board.
1 = Bearing
3 = PF scale
Step 3 :
Remove the PF encoder installation board.
Step 4 :
Remove the bearing.
Step 5 :
Remove the 4 screws fixing the PF scale installation board.
Step 6 :
Remove the PF scale installation board.
Step 7 :
Replace the PF scale assembly.
Step 8 :
Remove the screws fixing the PF_ENC assembly to the PF encoder installation board.
1 = PF_ENC assembly
3 = PF encoder installation board
Remove the following covers before replacing the PF_ENC assembly.
Side cover L: refer to "Removing side cover L"
2 = Screws (M3x6) fixing the PF scale installation board
4 = Screws (M4x10) fixing the PF encoder installation board
Rockhopper II series printers – Maintenance Manual
2 = Screws (M2x6) fixing the PF_ENC assembly to
the PF encoder installation board
75 AP-74065, Rev. 1.2, 27/09/04