Mac Address Write Enable Menu - MUTOH Rockhopper II series Maintenance Manual

6.3.3. MAC address write enable menu

It could happen that the computer cannot make connection with the Rockhopper II printer. If this is the case,
the MAC address of the Rockhopper II printer has probably been set to zero or incorrect.
To insert the MAC address into the Rockhopper II printer, please follow the instructions mentioned below.
Notes :
6.3.3.1. Request correct MAC address
Step 1 : Remove the Right Cover.
Step 2 : Remove the Ethernet Board Cover.
Step 3 : Onto the installed card you can see a sticker with a 'FM0 number'.
Notes :
Write down this number 'FM0 xxxxxx'. Important are the 6 digits 'x'.
Step 4 : Based on this number Mutoh Europe's service department can provide you the correct MAC
address for your printer.
Step 5 : Reinstall the covers.
6.3.3.2. Insert the MAC address into the printer
Step 1 : Power on the unit in a special mode. Press the [POWER] key to power ON the unit, while
simultaneously holding the [F1], [F3] and [Menu ↑] key.
Step 2 : The unit will start up in special mode. Following message will appear on the display.
F3 →
Step 3 : Press the [F3] key to select the option 'MAC Address'. Following message will appear on the
display.
Step 4 : Press the [F2] key.
For the MAC address, a unique number is assigned for each unit. Do not use this
function except when intending to recover following deletion of the MAC address.
Please note that this procedure is only available onto the Rockhopper II printers with
following firmware version or higher.
Rockhopper II : V2.00
* Counter *
Indication
MACaddress
* MAC address *
Input Password
Rockhopper II series printers – Maintenance Manual
InitMenu
207 AP-74065, Rev. 1.2, 27/09/04