MUTOH Rockhopper II series Maintenance Manual page 63

Step 8 :
Stick the heater strip onto the plate.
Notes :
Step 9 :
Stick (with silicone glue) the two press plates onto the heater strip.
50" model : X = 380 mm
64" model : X = 380 mm / Y = 1060 mm
87" model : X = 660 mm / Y = 1200 mm / Z = 1750 mm
Notes :
Step 10 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
Please make sure that there are no air bubbles under the heater strip. Air bubbles
below the heater strip could cause overheating of the heater strip.
It will take ± 1 hour to let the glue dry.
During reinstallation of the plate, make sure there are no cables stuck.
Rockhopper II series printers – Maintenance Manual
64 AP-74065, Rev. 1.2, 27/09/04